
Appliance repair · Fairfax County, VA
Ice Maker Not Working: What to Check Before You Call
Jem repairs refrigerators, washers, dryers, ovens and dishwashers at your home across Fairfax County. Call and he'll get yours fixed.
- 6 years hands-on
- $90 diagnostic
- 90-day parts & labor warranty
- Mon–Sat 8am–8pm
Quick answer
An ice maker that stopped working usually has a frozen fill tube, a failed water inlet valve, a jammed or failed ice maker module, a freezer running too warm, or a shut-off arm or sensor stuck in the off position. Check the arm, the water supply and the freezer temperature first, then call (571) 306-9390 for a repair.
Updated 2026-11-12 · Serving Fairfax County, VA
Ice makers fail more often than any other part of a refrigerator, and most failures are small. This page, part of our refrigerator repair section, covers the causes in order of how often they turn up and tells you which ones you can fix in your kitchen.
Is it safe to check anything yourself?
Yes. Everything below is a look, a touch or a switch. Do not disassemble the ice maker module or the water valve, and unplug the refrigerator before reaching behind it.
- The shut-off arm or sensor. Many ice makers stop when a wire arm is raised or an optical sensor is blocked by a piece of ice. Lower the arm; clear the bin.
- The water supply. Follow the thin water line to the shut-off valve, usually under the sink or behind the refrigerator. Make sure it is fully open. If the dispenser also gives no water, the supply or the inlet valve is the problem.
- Freezer temperature. Ice makers need the freezer at about 0 to 5 °F. If the freezer is only cold-ish, no ice forms; fix the cooling fault first (see refrigerator not cooling).
- The fill tube. Look at the small tube that feeds water into the mould. A plug of ice at its end means the tube froze; a careful thaw with a warm damp cloth often restores it, though a recurring freeze means the valve is dribbling.
- A reset. Many models have a reset button or a power-cycle procedure in the manual. One cycle is worth trying.
What are the common causes?
Frozen fill tube
Water that drips slowly after the fill cycle freezes in the tube and blocks the next fill. Thawing works once; if it returns within days, the inlet valve is not closing fully and should be replaced.
Failed water inlet valve
The inlet valve is an electric valve at the back of the refrigerator that opens for a few seconds each cycle. When the solenoid fails or the valve clogs with sediment, no water reaches the mould. A technician tests the valve for voltage during a fill cycle and for flow, then replaces it.
Jammed or failed ice maker module
The module holds the mould, the heater that releases cubes, the ejector rake and the motor. Cubes frozen to the mould, a stripped gear or a failed thermostat inside stop the cycle. Modules on mainstream brands are usually replaced as one assembly rather than repaired part by part.
Low water pressure or a clogged filter
Ice makers need enough pressure to fill the mould in a few seconds. A filter that has not been changed in a year or more, or a kinked line behind the refrigerator, starves the fill. If cubes are small or hollow, start here.
Control board or sensor fault
On newer refrigerators the main control board commands the ice maker. If every other check passes and the module tests fine, the board or a thermistor is suspected. This is the one cause where parts cost rises noticeably.
Appliance down right now? One call and we will get it fixed.
When is it worth repairing?
Almost always on a refrigerator that cools well. Valves, filters and modules are modest parts and the labour is short, so the job typically sits around or below the $204 Fairfax average that HomeAdvisor reports for appliance repair. The exception is a control board on an older unit; ask the technician for the part cost before approving.
What will the technician do?
They will confirm freezer temperature, run a manual harvest cycle, test the inlet valve and water pressure, inspect the fill tube and module, and check the filter and line. If the module or valve is on the truck, the repair is finished the same visit. For built-in Sub-Zero or Thermador refrigeration, the ice-maker assembly is brand-specific; see the luxury appliance page.
No ice? Get it looked at.
Call Jem and get your appliance repaired at home, across Fairfax County, VA and the wider DC area. Monday to Saturday, 8am to 8pm. $90 diagnostic, 90-day warranty on parts and labor.