Stainless gas range with a lit burner and the oven door slightly open

Appliance repair · Fairfax County, VA

Oven Not Heating: Electric and Gas Causes

Jem repairs refrigerators, washers, dryers, ovens and dishwashers at your home across Fairfax County. Call and he'll get yours fixed.

  • 6 years hands-on
  • $90 diagnostic
  • 90-day parts & labor warranty
  • Mon–Sat 8am–8pm

Quick answer

An oven that is not heating has, on an electric model, a failed bake element, thermal fuse, control board or one tripped leg of the 240-volt breaker; on a gas model, a weak igniter, a failed safety valve or a spark module. The igniter and bake element account for most calls. Check the breaker and settings, then call (571) 306-9390.

Updated 2026-11-12 · Serving Fairfax County, VA

An oven that will not heat is usually one part. This page, from our oven and range repair section, separates electric from gas ovens and shows what a technician tests, so you know what a fair diagnosis sounds like.

Is it safe to check anything yourself?

A few things. Nothing involving the gas valve or the wiring behind the back panel.

  1. Breaker (electric). Electric ranges use a double 240-volt breaker. If one leg trips, the clock and lights still work but the elements stay cold. Turn the breaker fully off and back on.
  2. Settings and modes. Make sure the oven is not in Sabbath mode, delay start or a demo mode, and that the door is fully closed on models that will not heat with the door ajar.
  3. Look at the bake element (electric). With the oven off and cool, inspect the lower element for blisters, breaks or a bright spot where it burned through. A visibly damaged element is the fault.
  4. Watch the igniter (gas). Set the oven to bake and look through the bottom vent or remove the oven floor panel if your model allows. The igniter should glow orange and the burner should light within about a minute. Glow without flame points to the igniter; no glow points to the igniter circuit, control or a thermal fuse.
  5. Gas smell. If you smell gas beyond the first seconds, stop. Leave the house, call 911, then the Washington Gas Emergency Leak Line at 844-WASHGAS (844-927-4427), option 1.

What are the common causes: electric ovens?

Bake element

The lower heating element burns through over years of cycles. When it fails the oven may still broil from the top. A technician checks it for continuity and resistance, then unbolts and replaces it: one of the quickest oven repairs.

Thermal fuse or high-limit thermostat

A safety device that opens if the oven overheats, often after a self-clean cycle. Once open, the oven is dead until the fuse is replaced. The reason it opened (a failed cooling fan, a blocked vent) is checked at the same time.

Oven control board or relay

The board switches the elements through relays. A failed relay leaves one element dead; a failed board leaves the oven unresponsive or showing a fault code. The technician checks for voltage at the element terminals when bake is called for; voltage missing with a good element means the board.

Temperature sensor

A sensor reading wildly out of range makes the control refuse to heat or shut off early. Tested for resistance at room temperature and replaced.

Appliance down right now? One call and we will get it fixed.

What are the common causes: gas ovens?

Weak igniter

The glow-bar igniter must pull enough current to open the oven's bi-metal safety valve. As it ages it glows but draws less, and the valve never opens. The technician measures the igniter's current draw; below the manufacturer's threshold, it is replaced. This is the single most common gas oven repair.

Safety valve

Rarely fails, but if the igniter draws correct current and the valve still does not open, the valve is replaced.

Spark module or electrode (spark-ignition ovens)

Some ovens use a spark electrode rather than a glow bar. A cracked electrode or a failed spark module means no ignition. Both are tested and replaced.

Thermal fuse or control

Same logic as electric: a fuse opened after a self-clean, or a control not calling for heat.

When is it worth repairing?

Almost always. Elements, igniters, fuses, sensors and spark modules are inexpensive, so the job usually sits at or below the $204 Fairfax average HomeAdvisor reports for appliance repair. The NAHB gives gas ranges about 15 years and electric about 13; even an older oven is normally worth a no-heat repair unless the control board is both failed and costly.

The repair-or-replace guide covers that case.

What will the technician do?

They will confirm power or gas supply, test the bake element or igniter under load, measure igniter current or element resistance, check the thermal fuse and sensor, and verify the control is calling for heat. Most no-heat repairs are finished in one visit, often in under an hour, with the part from the truck.

Oven cold? Call now.

Call Jem and get your appliance repaired at home, across Fairfax County, VA and the wider DC area. Monday to Saturday, 8am to 8pm. $90 diagnostic, 90-day warranty on parts and labor.

Call now Get a quote