Open dishwasher with the lower rack pulled out and a towel in front

Appliance repair · Fairfax County, VA

Dishwasher Not Draining: Checks Before You Call

Jem repairs refrigerators, washers, dryers, ovens and dishwashers at your home across Fairfax County. Call and he'll get yours fixed.

  • 6 years hands-on
  • $90 diagnostic
  • 90-day parts & labor warranty
  • Mon–Sat 8am–8pm

Quick answer

A dishwasher that is not draining usually has a clogged filter or sump, a blocked or kinked drain hose, a garbage-disposal knockout plug that was never removed, a blocked air gap, or a failed drain pump or check valve. The first four you can check in ten minutes; the pump needs a technician. Call (571) 306-9390.

Updated 2026-11-12 · Serving Fairfax County, VA

Standing water at the end of a cycle is the most common dishwasher complaint, and more than half the time the cause is outside the dishwasher or in a filter you can lift out. This page from our dishwasher repair section takes you through the checks in order, then the repairs a technician makes.

Is it safe to check anything yourself?

Yes. Everything in this list is reached from inside the tub or under the kitchen sink. Switch the dishwasher off at its control panel first, and expect dirty water.

  1. Filter and sump. Remove the bottom rack. Twist out the cylinder filter and lift the flat screen under it. Scoop out food, glass and labels from the sump. Run a rinse cycle.
  2. Drain hose high loop. Under the sink, the dishwasher drain hose should rise to the underside of the counter before it drops to the disposal or drain tee. A hose that sags lets dirty sink water flow back and lets the pump lose its prime.
  3. Garbage disposal. If a disposal was installed recently and the dishwasher has not drained since, the knockout plug inside the disposal's dishwasher inlet was never punched out. Also run the disposal: a disposal full of food blocks the dishwasher's only exit.
  4. Air gap. The small chrome cylinder on the sink deck (if you have one) can clog with debris. Lift the cap and clear it.
  5. Cycle interrupted. Opening the door mid-cycle on some models leaves water in; run a drain or cancel cycle.

If water still stands after those, the fault is the pump, check valve or control, and a technician is the right call.

What are the common causes?

Clogged filter, sump or chopper

Food debris, glass and seeds build up in the sump beneath the filter. On older models a chopper blade sits over the drain inlet and can jam. Cleaning fixes it; a jammed or broken chopper is replaced.

Drain hose problems

Kinks behind the dishwasher where it was pushed back, a crushed section under the cabinet, a missing high loop, or a plug of grease at the connection to the disposal. The technician clears or replaces the hose and corrects the loop.

Knockout plug or blocked disposal inlet

Common after a new disposal is fitted. A technician removes the plug in minutes. If the inlet nipple itself is packed, it is cleared.

Failed drain pump or pump impeller

The drain pump pushes water out at the end of each phase. A broken impeller, a jammed shard of glass or a burnt-out motor means the pump hums or sits silent. The technician checks for voltage during the drain phase and for impeller movement, then replaces the pump.

Stuck check valve

A small flapper in the drain path stops water flowing back after a drain. Stuck closed by debris, it blocks draining; stuck open, it lets water return. Cleaned or replaced.

Control fault

If the pump never receives power at the drain phase, the control board or a timer is at fault. This is less common and is the one cause where the part cost matters on an older machine.

Appliance down right now? One call and we will get it fixed.

When is it worth repairing?

Filters, hoses, plugs, check valves and drain pumps are low-cost repairs that fall at or under the $204 Fairfax average HomeAdvisor reports for appliance repair, so they are worth it on any dishwasher that otherwise cleans well. A control board on a dishwasher near or past the NAHB's typical 9-year life is where the repair-or-replace guide tends to favour replacement.

What will the technician do?

They will check the filter and sump, trace the hose under the sink, confirm the disposal inlet is open, then run a drain phase while testing the pump for voltage and movement. If the pump has failed, the dishwasher is slid forward a few inches, the pump is swapped from underneath, and the unit is run through a full cycle to confirm the leak-free result.

Standing water? Call now.

Call Jem and get your appliance repaired at home, across Fairfax County, VA and the wider DC area. Monday to Saturday, 8am to 8pm. $90 diagnostic, 90-day warranty on parts and labor.

Call now Get a quote